I don't have the Instruction Manual, so I don't know the pin assignment, but the terminal on the long side is Battery and the short side is Blinker connection. remove the Cap and turn the semi-fixed resistor on the Print board to Right to decelerate and Left to accelerate.
KITACO Connector set (item number) : (0900-755-02080) and Suspension for Honda OEM Relay (38306-KK4-000) will fit.
- Instock
57.56 USD (8,540 JPY)
Delivery Information
In Stock : 2 left, Ships within 24 hours.
Estimated arrival date around
FITMENT
-
Grom
13-
-
Grom
13-
-
SV650
17-20
-
GSX-S1000F
15-20
-
GSX-S1000
15-20
-
GSX-R1000
17-
See all
SUZUKI
-
Ninja 300
13-17
-
Ninja 250R
08-12
-
KLX300SM
21-
-
KLX300
21-
See all
KAWASAKI
Product detail
・2-Pin LED Flasher Relay
**The instruction manual, if included, will be in English.
Make sure that your motorcycle uses a 2-pin relay for the signal system.If your motorcycle has hazard lights, you may need a 4-pin relay that TST Industries can't accommodate.Also note the pinout and make sure it matches the one on your motorcycle to make sure it fits before you buy.
*There may be changes in product specifications due to the manufacturer's reasons..
This relay will fix your flash rate problem caused by aftermarket signal lights and / or integrated taillight.
If your signal lights flash too fast or do not flash, this part is your solution!
Plug and play - easy installation.
This component works with the following signal configurations:
All stock
Stock taillight, aftermarket signals
Integrated taillight, stock signals
Integrated taillight, aftermarket signals.
The relay comes preset to 85 cycles per minute.
You can alter the flash rate to make it faster or slower.
If you slip off the grey cover you can access an adjuster that will enable you to change the flash rate to your liking.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.