Avoid super-discount Chinese suspension and have a half-year warranty and made it a reputable U-CP's thing. I made it NORMAL color instead of OHLINS color.
Product Contents seems to be made in China, but it seems that quality control is done, it is a difference from the discount.
Looking with severe eyes, the Wound that seems to have attached at the time of manufacturing can be found, but I decided not to see it because it is a Level that can be taken with stepping stones etc.. Those who care about recommends OHLINS, but I will multiply the price by 10.
Although it was for CB 400 SF in the conformity model but there was no NC 42 notation, let me inquire to Webmaster by e-mail and there was a conformity OK answer and I had you purchase.
Although it is a ride, I do not know the severe, but the old OEM suspension I got on for 8 years (Oil bleeding) It is harder and harder than it is, it is not necessary to hang Pre-road.
You can do the installation by yourself, you can do it one by one without Jack, but if you make a mistake in procedure you will be disastrous, for VehicleJack is good so Jack-up enough to hit the rear wheel and hover the rear wheel Is absolutely easy.
CB 400 SF is girly unless you remove the Exhaust System and Chain Guard, but you can not put the bottom Bolt (Although it was missing). Let's take it from the beginning without impossible.
Rubber Bush on the top is hard to put in the installation, but when I painted Silicon grease I entered the installation.
Those who think that it is impossible for themselves, please make a decision to go to the Motorcycle store before removing the suspension, you can not run if you remove it.
- Instock
124.55 USD (18,480 JPY)
Delivery Information
In Stock : 1 left, Ships within 24 hours.
Estimated arrival date around
FITMENT
-
CB400SF
HYPER VTEC SPEC2 NC39
-
CB400SUPER BOLDOR
NC39
-
CB400SF
HYPER VTEC NC39
-
CB400SF
HYPER VTEC SPEC3 NC39
Product detail
Color: Red / Gold
[Size]
Center of mounting hole - length of center: Approx. 325mm
Spring Outer Diameter: 65mm
Spring wire diameter: 8.1mm
Rod diameter: 12.3mm
Inner diameter of Upper Mounting Hole: 16mm
Inner diameter of lower mounting hole: 10mm
Thickness of the upper mounting: 18.3mm
Thickness of lower mounting: 20.0mm
Tank Diameter: 49mm
**The image is for reference only.The size of the collar may vary depending on the model.
*There may be some small scratches on the product during production or transportation..
●Based on the concept of providing a suspension that can be used with assurance, this is an original suspension that has been completed through many trials and errors from planning and development to commercialization.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The length of the suspension can be set to almost the same as the stock suspension.
●The length from the center of the mounting hole to the center is about 325mm, which can be extended by 10mm by extending the end eye.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.