Windshield Racing

This is a Racing Type It's so thick and solid that you can clearly see that the windproofing has been improved
Installation was also just a JUST to the OEM Cowl, it took less than 30 minutes to Bolt On without much trouble It was a done deal
At high speed, the OEM type is a turbulent wind that hits the bottom of the Helmet from under the neck to the bottom of the Helmet, but this The Screen feels a bit windy around the top of the Helmet, but if you get down a bit, you can also feel the wind on the Helmet Unwind! It makes high speeds easier to drive normally
The screen is molded for easy viewing without distortion i'm wondering if you'd have a hard time with a wide angle because of the with stages, or if you'd have to adjust the Angle
Although it is taller than the OEM, wind cutting noise is not a problem, and above all, the style of the product is very attractive Race ish
This time [Color] With Clear [Color] I couldn't decide whether to use Smoke or not, but since it's a racing screen, I decided to use [Color] Clear is the right choice because it gives a clean look and a motorcycle makeover It was
It is a problem of preventing Screen from being scratched by the Seat cover, but it is a little difficult to be scratched It doesn't seem to scratch so badly, I'll consider the anti-scratch lining Seat cover in the future In addition, we are trying to fix the Seat cover so that it will not be affected by the wind
The weight is also a little bit but it seems to be light only for RACING, anyway, Makeover and high speed driving There is no doubt about the benefits
Most importantly, it's cool and neat

Although mere A-little middle was only rising, it was not understood that there was the protection-against-wind effect this much until it attached.
-- although there is also a more exaggerated Screen which is likely to come out and seems to be expensive as for the protection-against-wind effect, a Styling will not be barred, either but a Cool Type is this too.Being used for a Race is also convinced.This Race type (Double-bubble Type) is altogether attached also to the Motorcycle which rode after this [
].As a
supplement, trimming of a Rubber is attached to the Edge for automobile inspection correspondence.If injured on a Screen when surely it falls leaning forward, after it is dangerous.

Since the country road was run in many cases, it was worrisome that an insect hits a Helmet shield.So that a front disappears by the insect crushed when it was serious and 峠道 was run especially in summer at the sultry night.Even when it was high-speed, it was dramatically easy and the Shield also stopped almost becoming dirty after
Screen exchange, since a wind passes along a Helmet top.I think that good shopping was carried out.

Since he thought that he would attach this screen before changing to TRX, it is very much satisfied.
Although it is a racing screen, even if it has ridden usually, an effect is felt enough.
However, although he wanted the clear screen in fact, it was regrettable that a manufacturer does not have stock and it was not able to obtain.
When investigated, stock seemed to be slight also in its native country.

[Color] I bought it because I wanted it to be a Screen for Smoke.
The quality is good, moderately thick and solid.
Since there is no distortion, there is no distortion of the view when looking through the Screen.
Installation is also bolt-on, so simply remove the OEM and install in the reverse order.
[Color] The Smoke color is not pure black, so you can see the other side.
I think it is just the right density.