- Quantity to add Bar End:Exchange in SetThe Bar End for the Close type used in the past is said to have been discontinued, and the Open endSpec. Bar End was purchased.There is no particular change in t...Read More
- Used on CB250R.Pipe is a little long, so cut about 3mm for a just fit.The amount of Throttle manipulation was reduced by about 16%, making it easier to ride.Read More
- Apply a light coat of silicon spray and install.No installation problems, no drilling required due to open end.I'm not sure if it's because of the Teflon process, but it works much better.⇒ It has bee...Read More
- 딱맞아요 여기저기 검색후 cl500순정 스로틀튜브와 같은 제품이라는것을 알게돼었다 순정은 희색인데 이것의 ZETA 테프론으로 구매 데이토나핸들그립과 케이블이 딱 맞는다 내구성이 더좋다고하는데 그것은 좀더 오래 사용해보아야 할것같다 추천한다
----------------------------------------------------------
...Read More - The one I purchased this time was Open end in Black color.Color:It is combined with Gray's DRCGrip.Since the grip is 1cm shorter than the OEM KLX250es grip, the grip is a little on the Out side of the...Read More
- Purchased to save time when changing handlebar and grips.Since the 2017 CRFrally is Closed End,After the OEMGrip was stripped, the time to remove the rib and end of the Grip was wasted.Start with Hand...Read More
- I used it on my 97 KLX250es. The last time I used the same closed end Throttle cone with zeta's BaseGripClosed End, the grip was oddly short, ugly, and not easy to operate, so this time I used an open...Read More
- OEM is expensive and the delivery time is too slow, so being able to buy only throttle tubes is a big help.However, depending on the grips used, if thin grips are used, they may crack at the slightest...Read More
- Installed on CRF250L (MD47).I purchased this product to install ZETA's AdventureArmourGuard on my CRF.The installation process went well. Both Grip and ArmourGuard were installed without any glitches....Read More
- [How is it used?Model used:Z400Traveling:Touring, mountain passesReplacement from OEMThrottle; Holder is from OEM.Was the one you received as per Image?The inner surface of the body was smooth and see...Read More
- I purchased this product because I replaced the Handlebar.It was easy to install, but the hardest part was getting the wire through.I think it's a good idea to pimp it out.Read More
- To fit the KLX230R with the CloseType hand guard, the throttle tube was changed to match.You can Cut the ends off, but it's not an expensive product, so I bought an Open end Throttle tube.It's not a p...Read More
- It's a CRM250, but the OEM is already out of stock, so the Large variant is a big help.Read More
- I used it to convert my XR250 to High Solo.When replacing the Throttle, it is easier to assemble the Throttle first, then remove and fit the Handlebar.Read More
- Ordered the item for CRF250Rally. Colour RED. Quality is fantastic. Fitment is perfect. Installation work is easy. Highly recommended item.Read More
- I chose this one to run the Motocross course on a 2012 crf250l. zeta Handlebar and Hand guard and Pivot lever, I would like to have Grip as well.As you would expect from a dedicated product, it was a ...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING