- Used in YSR80.It is not listed in Webig's compatibility, but it is listed in the Manufacturer's compatibility list, so it can be used.Since the Spring was a replacement for a worn-out Spring, I could ...Read More
- I installed them on the NSR50 which I bored up to 63cc. The fatigue of the finger increased after running Circuit for half a day.Read More
- I exchanged for Maintenance at NS50F.Until then 1. Although there was not dissatisfaction especially at Standard Clutch Spring which used 50,000 km,After exchanging it, I realized that the control per...Read More
- When exchanging Friction disks, I also considered and simultaneous-purchase-did degradation of the Clutch spring.By the thing with strengthening, it can use satisfactorily 20% from the pure Spring.I ...Read More
- It is quite good, although it is recommended to a friend and a feeling differs from a purchase NORMAL for a while!! Since a Cost performance is also good, it is recommended!!
Read More - "Since the genuine spring was coming old, I purchased. The pitch of spring itself is choked up somewhat and longer than a genuine size. It is in a chamber direct carburetor in 50cc of actual condition...Read More
- Relation of a clutch became a direct.Read More
- Since bore up of the engine was carried out, it strengthened for the sense. Although he thinks that it is OK also with normal,Read More
- It purchased in order to carry out bore up and to prevent the slide of a clutch. Although it was a thing that it does not slide to the extent that bore up was carried out to 80 cc, it exchanged just t...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING