- The OEMSTAND was in an upright position, but as expected of an exclusive product, it is Exactly. The Bolt is very hard to install, so you will have to have the right tools to lick it off.Seat height i...Read More
- I installed it on my crf250lmd47 to make it look cool and solid.Read More
- Seat high of unmarked MD47 for me. (830mm) is a little severe and is lowered by about -16mm with AdjustableLINK.With this, the body of the car was standing up, so we decided to shorten the STAND as we...Read More
- I think the need is generally low, but the current Standard (21-year MD 47) I have been using ZETA AdjustableLowering Link to lower the seat height by -10mm, but I decided to use ZE56-8059 to shorten ...Read More
- When touring, I used to stop to think about STAND, but I can stop anywhere.Read More
- I replaced it because the OEM was so plain. I can't say that the effect is obvious, but the quality is satisfactory.With a single Screw, the length of the grounded part can be changed by changing the ...Read More
- We've been waiting a year for Short Stand!Great to use, feels just like OEM!Aluminum Cut-out texture and Zita's NameValue are also GOODRead More
- The parking lot of the house is slightly tilted.The installation of an Aluminum Rear box.Due to the above two points, there was a concern that the product would topple over to the Right Side when park...Read More
- I am using XWheel to make MOTARD, but the OEM length of X is a little too long for my vehicle, so I have replaced it with a +15mm tip.It's not that much lighter than OEM, but it looks better, so it's ...Read More
- Not RALLY50StandardLDOnly the LINK is installed in the replacement car, 2cm down, and the seat is removed 4cm.Front fork2.4cm stickerWith the above Spec.The body is leaning a little too much, but BMWs...Read More
- Since I raised the height of the car, I was worried that the motorcycle would fall over because of the large tilt when it was parked, and I was also worried that it would take up too much space in the...Read More
- The ground contact part of the STAND can be rotated and fixed, so you can set the best STAND ground contact position according to your motorcycle's parking position. I'm happy with the way it looks.Read More
- May not be right
I was worried, but it’s not
It's well-sized and more inclined, so my precious bike doesn't fall over. And
It is easy to raise the stand even when ridingRead More - When the WR250F was converted to MOTARD, the ride height was slightly lowered, almost like a vertical I bought it to make it tilt as it isThe result is a standard tilt, and it doesn't feel too much of...Read More
- Really a nice addition. As soon as I saw this product I was excited and hoped it performed as good as it looked. It does. The fit was very good, it works smooth and uses the stock bolt, sidestand swit...Read More
- There is no problem to replace it, just remove the NORMAL and replace it (Where it touches the ground.) and then tighten the bolts afterwards The body is aluminum, so you need to pay attention to tigh...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING