The year without USB before model change can be the same etc. as the one after model change.I think it would work well with MirrorMount Bracket for ETCAntennas.Read More- You can easily secure a USB power supply. No problem while driving.I took the + from the switch on my rear brake. (Check with Tester) Wiring is through the top of the Air cleaner to the Left Side Cove...Read More
- The purpose of use was, of course, to charge my smartphone. It was installed on my old REBEL250. I thought it would be easy to install it because the power supply can be taken out from the Brake switc...Read More
- I ran for half a day while charging my phone, and it was able to provide a steady supply of electricity without dropping off on the way It wasThe lid also closes with a snap, so you don't have to worr...Read More
- There is not much space for mounting in my katana and handlebar area If it is a brake switch, you can get it from the rear brake A tester is used to interrupt the probing terminals, and the Earth goes...Read More
- The power is taken from the brake switch, but the Stop-lamp is set to the LED In this case, it did not work due to insufficient voltage I had no choice, so I supplied power directly from the battery Y...Read More
- What was the deciding factor for you?It's easy to get a power supplyHow was your experience with it?I'm currently using it to power my cell phone etc. and it's very convenientAre there any disappointm...Read More
- I have a Cigar lighter socket but no USBSocket, so I installed it I did1. First of all, look for the Plus terminal of the BrakeSW terminal with tester...2. The next step is to decide the position of t...Read More
- i installed it on a sc54 2007 model. earth to Horn's installation BoltIt was easier than taking power from the Fuse box, but the Plain Type Terminal Size is suitable, but the power supply can be taken...Read More
- I was able to interrupt the brake switch and take out the power easily, but the Flat I am worried about an electric leak through the gap in the terminal I am considering taking power from another plac...Read More
- It's very easy to install because all you have to do is replace the brake switch terminals and take off the Earth It was easyIt takes less than 5 minutes if you don't have to worry about the wiring ar...Read More
- I bought it for charging my phone because I changed my motorcycleIt was a spec. that takes power from the front brake switch, but for some reason I interrupted the Cable of Tail lampThe port is fixed ...Read More
- On the Minus side, remove the front cowl and tighten the front cowl to the other grounding wire, then add the Plus side is made to interrupt the Wiring of Brake switch, and the extra Wiring is bundled...Read More
- I've been looking for a USB power supply for some time now, but I'm not sure what to expect I liked the fact that this product works with the Main key It was not too difficult to install, I took it fr...Read More
- As in the Instruction Manual, Wiring only connects between Brakesw.Mounted Grounding Wire in the hole of BKT under Front fork.Controller, but CB has no place to hide in the presence of Cowl and is pas...Read More
- I was planning to use the Compact Jump Starter as a power supply, but since I did not go into my Accessory Case of Motorcycle, I installed it properly.It took time to walk around, but Wiring was able ...Read More
?
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING