- I'm sorry I couldn't provide a photo, but when I used it on my NINJA2 Helmet 50RSL, I compared it with the OEM one, and the shaft part that holds the pad is clearly thinner,The measurements were taken...Read More
- [How is it used?Rusty Pad pin for replacementWas the one you received as per Image?YesWas the installation difficult?NoHow was your experience with it?It is safe from rust because of salt damage area....Read More
- OEM pad pins are made of steel and rust quickly. This product is rust-free and easy to maintain. Iron pad pins can absorb things like iron sand, and if not maintained for a long time, they can absorb ...Read More
- I tend to remove the pad spring because I don't like the trivial drag of the Brake, and as a result, it wears well with the OEM pad pin.Stainless steel is strong and does not wear as much as OEM and p...Read More
- I usually use OEM, but this is the first time I'm using OEM. OEM is getting strange wear & rust even after applying CopperGrease. I wish they didn't rust. I will replace the pad when I replace it, as ...Read More
- It's been a few years since I replaced it when the OEM rusted out.Naturally, there is no Rust whatsoever.The only thing is that the hexagon bites into the head.So, if you use Caliper for a long time, ...Read More
- I use it on my RearCaliper.I wasn't looking for firmness, but to use a slotted screwdriver.I didn't like it, so I replaced it.Thanks to this, I can use it without worrying about licking it.Read More
- This is a Brake PadsPin from Daytona for Nissin.I purchased this because I had tamed the NORMAL Pin, but because it is Stainless Steel, the texture is good, and because it is naturally an Exclusive De...Read More
- At the time of Pad exchange, I replaced it with Stainless Steel. Is it a little high?Read More
- i used it for cb400sb I don't feel that it became so light in part Single Body, but I think that the occurrence of Rust etc. disappeared However, I think that the occurrence of Rust etc. has been redu...Read More
- These are the front and rear normal calipers for CBR400RR/NC29 It is used in many middle class on road motorcycle of Honda Nisshin's PinSlide-style single-pod Caliper and Rear's 1-pod It is used for C...Read More
- The NORMALPad pins on the Brembo caliper are very rusty, aren't they?It's a pain in the ass to install and removeThis will not rustIt goes in smoothly, tooEasy!Forever Polished!It's for 4 pot casting ...Read More
- 【What made you decide the purchase?】- Enamel to prevent fallout of Pin seemed to work better in Hexagonal Wrench.【How was it actually used?】- OEM is easy to loosen when Screw loosens with Slotted scre...Read More
- It is a part that needs to be replaced regularly because it will hinder the movement of Brake Pads due to stepped rust and rust.I can cope with rust with polishing, but I recommend you to exchange it ...Read More
- Even in the rain, Motorcycle commuters so we exchanged for rust prevention. (I attached it to the Casting caliper of brembo. )You need to remove and install badboOEM's Pad pin with Plastic hammer,...Read More
- We are using Honda FUSION after reselling.Caliper itself seems to be the same as NC 31 and CB 750.Corrosion of OEMPin is severe, with water-resistance paper etc.I polished it and reused it, but the ne...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING