I use it to control YOSHIMURAMJN - TM 24 with XR 100R. When used for PD22 of XR100 REMEM, since OEM's Throttle Wire can not be removed from Top cap of PD 22, Takegawa's Top cap (Out of print?) Can be used without problems if replaced with (NSF 100 should be using Throttle and carburetor of almost the same form).
You could use it for YOSHIMURAcarburetor. Wire handling should be taken Large. There is no problem in the adjustment range of Wire's play.
High Solo feeling is the same as XR100ROEM or feeling that it became High Solo.
The attached DAYTONA 's Grip is neither nor impossible.
I bought this High Throttle for my Honda RS150 that fits perfectly. The quality of the item and the finish is great. I have to modify the item as i instaled it in a throttle body rather than the carb recommended but it still fit fine. This is cheap throttle an alternative throttle for a premium throttle. The item is package nicely. It was ship wraped in bubblewrap so item is protected. Make sure that the length of the cable is compatible witj the motorbike your going to use. View Detail
Hi all,This throttle, grips and cable are great quality, great fit and finish, East to install. I would highly recommend this product to anyone looking for a good quality throttle.View Detail
fitted extremely well, good quality and a great over all feel. has smooth operation whilst still having a stockish look. great comfort from gripsView Detail
Not suitable for street youth.
For Circuit.
Reason:Because it is difficult to adjust Speed with Throttle alone.View Detail
I thought that it was good for the repair measure of the accelerator wire off of my friend's SUPER CUB C50 modified 124ccPipe HandlebarSpec. and introduced it.
The carburetor and accelerator wire of a certain Horizontal TypeEngine 124cc Full kit became bad, and the carburetor was changed to YD28.
The taking out position was changed, and it became better temporarily, and it was relieved.
However, when I heard that Axel didn't return after switching back, and I visited to check, I found that there was a dislocation of the Accelerator Wire attachment part of the Switch box original.
I have repaired and adjusted the handlebar many times, but the angle of the handlebar cut, the length of the wire, and the position of the fitment were not good, so I gave up and considered a new installation.
I picked up a few kits that are hard to remove, easy to adjust, have long guide wire, high solo, and repair parts available, and have standard long wire that corresponds to the length of CUB frame.
At any rate, I'll replace the Grip at his request, and until he has more time. "Take the Small stuff home and work out the tentative matches and Ideas. So, I worked on it.
This is a perfect feeling. I'm looking forward to installing everything into the car and driving it in the real world.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING