Rear Fender of '10 type Z1000 has a cavity in the Small soak LINK part
Roll up mud and water just because the road is slightly wet
Suspension and sometimes to Helmet
(It is useless because it is a Fender Eliminator that attaches Helmet)
Because water and mud will adhere, we consider Fender of Other Company Product.
By selecting FRP as an inexpensive thing, select this item.
There is no distortion of Body and Screw hole gaps and it is completed in about an hour.
Since there is no cavity, there is no worry that Suspension will be directly contaminated.
After that, I will check if the mud splashes back to the back run.
However, only one ...
Handling Instruction Manual Why? "ZrX1200DAEG" Goods for
I was in.
Because there was Webike's invoice in the box
I think that it is inspected, but I want to have your attention once more.
Purchased Black Gel product.
Mud splatter on the rear suspension is drastically reduced, and the area under the seat is less likely to get dirty.
It is also good that the Side view looks Race ish.
I think it would be faster/easier to remove the Rear tire for installation as a result.
Unlike OEMChain Cover Material, Material:FRP?
Hit by a Small stone or a nail that has been stepped on by a Rear tire may cause chipping.View Detail
Black Gel purchase
There are some small scratches and bubbles left on it, but there are no cracks It was sturdy, but not Large
We didn't have to do any modifications during installationView Detail
VTR250 ('05) What
Rear suspension and Seat purchase to mudguard behind
I could prevent muds to Suspension, but it was not good for the back of Seat.
As a way of wearing, it was easier to follow from Tire instead of turning from the side and attaching from the back.View Detail
I installed it in the VTR 250 made by 2015.
If I do not remove the Tire, I think that the installation interferes with the Inner Box and it is muzzy.
Regarding the finish and mounting of the product, there is no problem.View Detail
It builds and the position of the
tapped hole has no problem.The Fender itself was merely distorted a little, and although it was not just by having rubbed, when seen from the back after
attachment, the
It attached with VTR of 2012 models.
It builds and the position of the
tapped hole has no problem.The Fender itself was merely distorted a little, and although it was not just by having rubbed, when seen from the back after
attachment, the Center line had shifted to quite the left.
Although it was Attach and remove the
Tire, since an amateur could not remove, where it vacated the
sheet, only the bottom removed the Bolt of the Frame and a Frame is raised upwards, it attached and carried out.(As it is, it interferes with a sheet and an accessory case, and cannot attach.)
run result
I have done the run comfortably, without rubbing and also regard appearance as whether it has melted into the original Design well.
> general comment To those who are straying purchase, since it is really [
] molding, I think whether the distortion of some is good to be determined.
-- if it is not a blank to the extent that that can be allowed and it rubs, be alike in mud -- since it is released from the phenomenon in which a Rear suspension and a Pants become dirty, I would like to carry out a Recommendationif anxious [ since it is related for the
Frame to raise and a Bolt is only removed, difficulty is low, but ] -- a store -- also leaving -- I think whether to be a hand.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING