22.81 USD
(3,450 JPY)
21.82 USD
(3,300 JPY)
(4% OFF)
3 (8 Reviews)
Average
Installed on XG250 TRICKERI bought it a few years ago, but it tore and I bought it again
The last one I used cracked after about two years and tore in the third year
One Side was torn, but the other side was still usable
It depends on how you use it, but I think the durability is not bad
A solid Instruction Manual is included, and the XG250 TRICKER It shows an example of installation of the system to a
The ForkOuter side is tighter and the Inner Tube side is looser
The length is just right
There are no holes in the air vent, so you'll have to empty them yourself
If you don't open it, it's quite tightly sealed and the fork sounds like a pushy sound
It's not the sloping bellows of the old off-road motorcycles
I think it can be used for classic style motorcycles
Reviews For ACTIVE Fork Boots From Other Webike User
Average
Sure, it's easy to get.The downside is that it's airtight, and if you don't drill holes in it, the air can't get where it's going. Well, I did some personal research, and I found out that one of the manufacturers had air holes from the start, but it looks like it's already been sold.
I hadn't heard of him before I looked him up.
What you can't buy is what you get, because the XG250 TRICKER doesn't have Boots.View Detail
Average
Mounting on SEROW 225 wIt installed in SEROW 225 w.
I like the appearance is Slim.
The texture is also shiny and matte finish so it looks cheesy.
Since the air holes are not open, we drilled three holes in the upper and lower center.
Another one in length. I am happy to have about 5 cm, but it can be used without problem.
I used the SEROWOEM's top Band, the bottom Band used the attached Tie Wrap that was attached to it because the attached one is too rough and it looks like it looks.View Detail
Very Good
TightlyI installed it because I did not have Boots on Tire exchange. I examined it with Net so I think Just fit! Length should be longer 2,30 mm longer, but it is ok. I am curious to hear a sound when stroke.View Detail
Average
Recommended for those who want to protect Inner Tube cheaplyI started riding the DF125 DJEBEL which was a stationary car and purchased it because the Fork Boots which had become stiff when riverbed was playing has torn..
As you can see from the photo, it is a little shorter & thinner than the OEM, so it changes to a SMART look.
Tie Wrap, Fixed Band is also included so you can install with this product only.
However, if you do not open the air hole at the time of installation, shape changes when Fork elongates, so you need to be careful.
Even if it keeps on it I think that afterwards I will protect Inner Tube without problems.
Because it is cheaper than other manufacturer's products, it is divisible as if it can not be helped.View Detail
Very Good
It is cheap and saved for out-of-print cars.Because NX 125's Fork Boots seemed to be a ghost of a lantern, I bought it for exchange.
OEM Parts Number is out of print and even afterMarket, there is no color thing close to OEM at this Size, after all it painted with dyed Q and installed.
Rubber quality is soft, the surface is not so beautiful Rubber's thickness is also firm and solid. Furthermore, because there is no air vent hole like OEM, we dealt with opening a hole before installation.
Included Parts : As for the upper and lower fixation, Gold genus Band and In Hemp palmk are attached, but without using it, I fixed it securely with the OEM's gold tool and I could secure firmly just by inserting the bottom. It does not seem to get out.
The price is cheap, Included Parts : And the Instruction Manual are solid, so I think that this is a bargain.View Detail
Most Viewed Reviews Of ACTIVE Fork Boots / Fork Covers
Average
Sure, it's easy to get.The downside is that it's airtight, and if you don't drill holes in it, the air can't get where it's going. Well, I did some personal research, and I found out that one of the manufacturers had air holes from the start, but it looks like it's already been sold.
I hadn't heard of him before I looked him up.
What you can't buy is what you get, because the XG250 TRICKER doesn't have Boots.View Detail
Average
Mounting on SEROW 225 wIt installed in SEROW 225 w.
I like the appearance is Slim.
The texture is also shiny and matte finish so it looks cheesy.
Since the air holes are not open, we drilled three holes in the upper and lower center.
Another one in length. I am happy to have about 5 cm, but it can be used without problem.
I used the SEROWOEM's top Band, the bottom Band used the attached Tie Wrap that was attached to it because the attached one is too rough and it looks like it looks.View Detail
Very Good
TightlyI installed it because I did not have Boots on Tire exchange. I examined it with Net so I think Just fit! Length should be longer 2,30 mm longer, but it is ok. I am curious to hear a sound when stroke.View Detail
Average
Recommended for those who want to protect Inner Tube cheaplyI started riding the DF125 DJEBEL which was a stationary car and purchased it because the Fork Boots which had become stiff when riverbed was playing has torn..
As you can see from the photo, it is a little shorter & thinner than the OEM, so it changes to a SMART look.
Tie Wrap, Fixed Band is also included so you can install with this product only.
However, if you do not open the air hole at the time of installation, shape changes when Fork elongates, so you need to be careful.
Even if it keeps on it I think that afterwards I will protect Inner Tube without problems.
Because it is cheaper than other manufacturer's products, it is divisible as if it can not be helped.View Detail
Very Good
It is cheap and saved for out-of-print cars.Because NX 125's Fork Boots seemed to be a ghost of a lantern, I bought it for exchange.
OEM Parts Number is out of print and even afterMarket, there is no color thing close to OEM at this Size, after all it painted with dyed Q and installed.
Rubber quality is soft, the surface is not so beautiful Rubber's thickness is also firm and solid. Furthermore, because there is no air vent hole like OEM, we dealt with opening a hole before installation.
Included Parts : As for the upper and lower fixation, Gold genus Band and In Hemp palmk are attached, but without using it, I fixed it securely with the OEM's gold tool and I could secure firmly just by inserting the bottom. It does not seem to get out.
The price is cheap, Included Parts : And the Instruction Manual are solid, so I think that this is a bargain.View Detail
Other Reviews From Japan User(translated)
Excellent
Radipon handled in Mild?attachment
The CBR650R is mounted at the same position angle as the NORMAL.
However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away.
I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose.
・NORMAL (Reserve integrated horizontal master) Impressions of
No complaints on public roads. Familiar feel and very easy to handle.
However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful.
Radipon (Reserve separate body portrait master) Impressions of
It was totally different from what I expected, my expectation was that it would feel like a Rear brake…
It is really a mild and easy-to-handle radipon.
On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN?
But I felt the radipon effect from Breaking a little stronger, and
It can be hung up to a hard brake without effort.
I felt trust that this could stop.View Detail
Very Good
packtalk bold Attached MountI purchased this for use with multiple Helmets. 。
Mount included with the BOLD.
Microphone and speaker are not included and must be purchased separately.View Detail
Excellent
Grip replacementGrip that had been used for a long time was worn out and had to be replaced.
They are soft and dampen vibration.View Detail
Very Good
Works well in everyday life[How is it used?
Used to lick Screw loose.
Was the one you received as per Image?
As per Image.
How was your experience with it?
When used on a strongly tightened Screw, it can be safely and securely removed.
The licked Screw was removed.
It is also useful for DIY Screw removal.
[Points to note]
When used on a licked Screw, it is best to beat it in with a Hammer before use.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING