* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
We use cookies to provide and improve our services. By using our site, you consent to our Privacy Policy including cookie. Learn more
The other day, I went to the forest road, and I was defeated because of the bad footing, so I decided to lower the vehicle height with LINK. I love that it's the easiest and cheapest way to get it down!
The most difficult part is to find a way to loosen the bolt holding the LINK.
When you replace it, you can feel the difference. By the way, both feet are not sticky feet. However, since it reaches to the belly of the finger, the power enters properly. It's great to be able to ride a motorcycle with a good footing because it gives you a psychological sense of security. Also, these 2cm will help you a lot when you are on a forest road and you have a mishap.
I'd highly recommend it to anyone who enjoys forest roads on a RALLY 50 and is put off by the Seat height!
It's installed on a CRF250RALLY. It's Standard, not LowdownMODEL, but the seat height became higher (precisely because the spring rate became harder and less sinking?) by replacing the front and rear suspensions. Because of this, I decided to use Lowdown Link.
First of all, the height of Seat itself will be lowered by using Lowdown Link, but the sinking of the Rear Suspension in relation to LINK will also be Large
The exchange itself can be done with simple equipment. We did it at home. In the case of CRF250RALLY, Under Cowl is the Material:It is plastic, so you need to be careful not to raise it by jack as it is.
After the replacement, it's very easy to ride. Also, the reddish parts that you can see underneath the Swing Arm are surprisingly noticeable, and I think they help with the dress-up. I think it helps with dress-up.View Detail
excelent lowering link. very good craftmenship.very easy to install all parts needed to install are includedthe bike sites 2.5 cm lower then standartView Detail
About quality and texture : The product looks neat and sturdy, so I can trust itAbout the feeling of use : I felt much more at ease because the height was lowered.I can do well in reverseProducts to buy together : If the height is high, please purchase the low sheet togetherDifficulty of installation :I want you to use the maintenance centerCost performance and comparison with other products : I'm satisfied with the price/performanceAbout shipping and packaging : be well packed and deliveredAny concerns, cautions, or advice when purchasing : If you are worried about the height, I highly recommend it.With a low seat and a low kit, you can ride with satisfactionView Detail
My YZ125 was too tall for me, My height measured at 167cm. So the lowering link was one of the options to lower down the bike. ZETA products does not dissapoint as it's finish is perfect and the installation was smooth. Bearings are included however it's advised to add additional grease in when installing. Post installation, I can at least touch the ground whilst sitting on the bike. Additional lowered seats is also a better combination. View Detail
Был приятно удивлен, товар пришёл в течении 7 дней, без учета дней обработки заказа. Товар качественный всё нормально, упакован отлично, советую всем кто хочет немного занизит мотоцикл, новички не бойтесь заказывайте смело, пока еще на мотоцикл не установил, в комплекте по мимо опускного звена были ещё два сальничка. В общем доволен остался. Курьер вручил прямо в руки, приехал ко мне домой и вручил. Всем советую, не пожалеете.I was pleasantly surprised, the goods arrived within 7 days, excluding the days of processing the order. The goods are of high quality, everything is fine, packaged perfectly, I advise everyone who wants to underestimate the motorcycle a little, beginners do not be afraid to order safely, until you have installed it on the motorcycle, there were two more glands along the lower link. In general, I was satisfied. The courier handed right in hand, came to my house and handed. I advise everyone, you will not regret it.translated by googleView Detail
очень понравилось качество товара,получил свой заказ буквально за восемь дней, все было упаковано очень хорошо, всем советую покупать запчасти для тюнинга именно на этом сайте, новички не бойтесь заказывайте смело обработка будет около трех дней потом отправят ваш заказ, именно это понижающее звено мне очень понравилось, понижающее звено пришло такое же как на фото здесь на сайте, всем советую.I really liked the quality of the product, I received my order in just eight days, everything was packed very well, I advise everyone to buy spare parts for tuning on this site, beginners do not be afraid to order it safely, it will take about three days to send your order, it’s this lower link to me really liked it, the lowering link came the same as in the photo here on the site, I advise everyone.translated by googleView Detail
?attachment The CBR650R is mounted at the same position angle as the NORMAL. However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away. I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose. ・NORMAL (Reserve integrated horizontal master) Impressions of No complaints on public roads. Familiar feel and very easy to handle. However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful. Radipon (Reserve separate body portrait master) Impressions of It was totally different from what I expected, my expectation was that it would feel like a Rear brake… It is really a mild and easy-to-handle radipon. On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN? But I felt the radipon effect from Breaking a little stronger, and It can be hung up to a hard brake without effort. I felt trust that this could stop.View Detail
I purchased this for use with multiple Helmets. 。 Mount included with the BOLD. Microphone and speaker are not included and must be purchased separately.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING