Pulley Holder

This tool does what you're asked if you use it for its intended purpose. Bought it to hold the flywheel on my Honda crf250r while tightening the nut. Some mentioned that it failed and didn't do its job. Don't use it to change the oil filters in your car or put on your ex-girlfriend's tire and it should work just fine.I've used it on a few bikes, KTM and Honda it still looks and works as it should. I would buy it again as it's the right price for a tool you can use about 6 times in your life.shipping is very fast,well packaged, thanks webike.

In overhauling Clutch of SUPER CUB, a tool to fix Clutch became necessary. There were several kinds of tools to fix, but I chose Pulley holder which is tenacious for the time being

Clamp the Holder in Clutch, rotate the handle and tighten it to complete the set. I was able to remove it easily by putting pressure on Lock nut using exclusive Wrench. Clutch that was immersed in oil can also be fixed without slipping

I found out when using it, but Clutch still moves with just being caught in Pulley holder. So when detaching you must hold down the handle or hook it somewhere so as not to move. Naturally? - ω - `)

Purchase for Clutch exchange.
Quality was also good and could be used without problems

The price is reasonable as it is

Because it can only rotate by 180 ° in the attached Lever
I felt uncomfortable with a small car like 4 MINI.
If the tip is hexagon etc. so that it can be used even with Spanner etc.
I thought it was more convenient to use.

I used it for desorption of Pulley of CYGNUS1YP.
Shaft is attached to the Handlebar part so that it can be tightly tightened, but if you tighten it with so much power, you can hold it firmly.
Initially, I wondered whether to become Universal wrench, but because the hooked part is deep, it is hard to use (Not available) Because there was information that it was made to Pulley holder. Results were purchased and correct answer was Large.
There is no place to use it, but the Red Rubber to hold it is weaker than we thought, it will be soooolid but it seemed like it was good to have bought it after a long time.

I watched Impre, I decided to buy it as a reference.
Good feeling because it can be used for Clutch exchange and Outer Rotor exchange.
Whether it's a little expensive or not.
I just pray that it will not break afterwards.