Ready-to-Hang Bike Cover 2L

■Product Features
・It only takes 10 seconds to call
・Orange handles and zipper make it easy to see the front and back of the cover
・The inside of the cover is made of a heat-resistant cotton material with a temperature of about 360 degrees Celsius.No need to wait for the engine to cool down
・Once squeezed, the sole squeezing function does not require adjustment
・With a belt for wind-skipping prevention and cover storage → space-saving cover storage!No more soiling the cover when storing it!

■ Put it on and feel it!Bike cover that can be put on a bike in 10 seconds
Just take the orange handle and rear zipper and quickly put it over the front of the bike, then just pull it on.
Just pull it backwards to apply the cover securely, so there's no need to spread it out like a flap!!!
It can be applied in 10 seconds with no wasted motion.

When the cover is placed in a crumpled position, it is difficult to tell the front and back of the cover, and it is necessary to spread it out.
With this bike cover, you don't have to unfold the cover, with orange handles and zippers that are easily visible through the silver fabric!
You can tell the front and back at a glance.

Cotton fabric with a heat resistance temperature of approximately 360 degrees is used so that the exhaust pipe, which is actually hotter than the exhaust, can come in contact with it.
While other companies' heat-resistant motorcycle covers use cotton fabric at an angle, focusing on the area where the exhaust hits, this motorcycle cover covers the area that gets hot and prevents the cover from melting and sticking to the exhaust.

Many bike covers should have a center buckle to prevent wind skipping.
However, the cover may melt by sticking to the engine parts, or by touching the hot parts where the cotton fabric is not attached....
Above all, it's very cumbersome to put on and take off!
In order to shorten the time required for this, a function is adopted that allows the bottom to taper so that once it is tightened, there is no need to loosen it again.

With the conventional thread-squeeze function of the bike cover, it is necessary to loosen the cover each time it is put on or taken off.
With this bike cover, the rear zipper allows the cover to be attached and detached even with the soffit closed.

It's a hassle to put locks on both the front and rear lock holes... If this is the case, you can attach a belt to one of the locking holes to prevent the wind from blowing off.

Bike covers are large, so many people have trouble finding a place to store them.
In an apartment or condominium, the only place to put a bicycle is on the balcony of your room or on the ground of a shared bicycle parking lot....
But if you put it on the ground, it gets so dirty with sand and dust that the next time you use the cover, the dirt gets on the bike and the cover is useless!

The attached belt can be used to put them together to save space and keep them in a place where the cover will not get dirty.
The cover can be hung on a clothesline when wet, so it can be hung to dry properly.

Other features include air vents to prevent steam inside the cover, a 40mm diameter lock hole for motorcycle security, and over 90% UV protection!
It has many features, including a water-repellent 300D thick fabric!

■How to care for the product
・To protect the water-repellent effect of the fabric, please do not use a washing machine or wring it out.
・For stains, rinse with lukewarm water or water, or wipe with a cloth dampened with diluted neutral detergent and squeeze tightly.
・If the cover is left with dust or dirt on it for a long period of time, the water repellent effect will be lost.