- Instock
101.03 USD (15,588 JPY)
Delivery Information
In Stock (Partner's Warehouse): 1 left, Ships around 28th Feb. 2025
Estimated arrival date around
FITMENT
-
790 DUKE ABS
18-20
-
890 DUKE R
20-21
-
890 DUKE
21
-
790 DUKE ABS L (A2)
18-20
Product detail
[Manufacturer's Part Number] 280-312H
*
*If the instruction manual is attached, it is in a foreign language because it is an imported product.
*There may be changes in product specifications due to the manufacturer's reasons..
* The image is only for reference. The image shown may differ from the actual product.
HIGHSIDER AKRON-RS license plate holder
The HIGHSIDER AKRON-RS license plate holder adapts perfectly to the lines of your motorcycle thanks to its design.
The model-specific bracket of the HIGHSIDER AKRON-RS allows mounting on the original mounting points of your motorcycle and thus a replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.
The license plate is made of sheet steel and 2mm thick. The precise cutting is done by laser. After edging, the weather-resistant black powder coating is applied.
This ensures the optimal fit and durability.
Through the full adjustable you can bring the plate without drilling in the desired position. To keep the plate in this position, there is an additional locking screw.
The turn signal brackets of the HIGHSIDER AKRON-RS are adjustable in width and therefore suitable for any type of accessory turn signal. This adjustment option allows you to adapt the position for your turn signals to the most varied license plates. To allow mounting the turn signals without disconnecting them from the wiring harness, the 10mm holes are slotted to the side.
You can also adjust the position of the reflector individually via a slider. An adaptation to the different designs of the EU license plates is therefore no problem.
To screw the license plate securely and reduce vibration, two rubber washers are included. Another rubber buffer supports the license plate on its underside.
Details:
- model-related bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixation without further work steps (eg. Drilling)
- easy mounting of the license plate through slotted holes
Included in the scope of delivery of the HIGHSIDER AKRON-RS are:
- Model-related bracket with mounting parts
- HIGHSIDER AKRON-RS license plate retaining plate
- Adjustable turn signal brackets
- E-tested reflector with adjustable bracket
- Mounting instructions
Notes:
- Since the original tail light of your motorcycle is omitted when mounting this license plate holder, we offer you a suitable replacement in the accessories tab. There you will find our modern and for road traffic approved 3in1 combinations.
- If your original license plate holder has reflectors fitted to the side,these must be refitted in a suitable position or replaced with new ones.
- For the original blinkers we offer you, also in the tab accessories, optionally a special blinker holder.
Tips:
If you have not found a model-specific license plate holder for your vehicle, then you will certainly find the universal license plate holders from HIGHSIDER, which are available in many different designs.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.