*Please make sure to check the year of your vehicle. *Stomp Grip's adhesive is very strong. ・Please take special care when attaching to the frame surface. ・If you remove it forcibly, the paint may be damaged or peeled off.When peeling it off, heat it up with a heat gun or the like to reduce the adhesive strength after peeling it off. *The image may contain other colors and products. *There may be changes in product specifications due to the manufacturer's reasons.
STOMP GRIP is used by top racers and top stunt riders all over the world. It is very popular in the circuit and the street in Japan. The number of users of STOMP GRIP is increasing all over the world.
[stomping on stomp grips] 1. Clean the surface to be applied.(When using clear, please remove dirt and water stains with compound before starting work) 2. Degrease the surface to be applied. 3. Perform positioning. 4. Apply from the edge so that air does not enter.Peel off the backing paper while pasting.(Take your time and apply slowly from the edge, little by little) It takes 24 hours for the adhesive strength of Stomp Grip to stabilize.Full adhesion requires 72 hours. If you use the product before it is fully bonded, it may peel off or shift. *Please pay special attention to the stomp grips that are attached to the frame surface.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
[How is it used? For High speedTouring and Circuit running of Ninja400.
Was the installation difficult? It is easy because it is originally only pasted, but I wore Large and stuck it in a short time, and the position became bad. Because the glue is very strong, it is impossible to paste again. Let's work carefully so that it doesn't become like this. If you are clumsy with your hands, you may want to leave it to the shop.
How was your experience with it? I can now use my knee grip to hold on even when I use powerful brakes. I can now hold my outside leg while bunking more stably and use my body more aggressively.
[Was there anything that disappointed you? If your pants are too thin, they will dig in and hurt. I'm not complaining because I'm convinced I'm using it, but I don't think I need something with this level of performance if I'm just going to be touring slowly.
Point and hang of installation Please do the degreasing with Silicon remover etc. enough. It will cost you a lot of money to buy a new one if you put it on wrong, so you should put it on after aligning it enough.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!