[Highsider] Turn Signal Proton TWO

Very Good

Dec 28, 2021

Amazing brightness

It is surprisingly bright even though it is a polar SmallSize of Almond Large.
ECE certified, so it can be used for vehicle inspection. [Color] Clear

Helpful?

MT-09SPFront blinker replacement

Excellent

Nov 22, 2021

The front blinker of the New Model MT-09SP is very easy to come off, and it comes off when you fall down. I removed the cover and re-installed it from the back, because it requires considerable time and effort from the front, I replaced it with this very SmallBlinker which does not fly out from the Radiator cover.
It is the Blinker of the Japanese Vehicle Inspection Correspondence, but if it is pointed out at the time of the vehicle inspection, I do not want to cut the Wiring of OEM as much as possible so that I can return it immediately. When I tried to make a Coupler separately, I got impatient.
It seems to be the WaterproofConnector of Sumitomo Wiring Systems, and I bought the one that looks like it while comparing it with the image, and thought of replacing it, but now the Crimped Pliers is missing.
Because the terminal is smaller than the usual Bullet Terminal, I purchased the recommended Hozan product separately, and also prepared the Wire stripper which corresponds to the thin Wiring, but it is a little depressed by the unplanned expense.
The cat will try to lend a hand while you work, but it's the recommended tool, so you'll have a shot at removing the thin Wiring coating.
Note:Even if you crimp the terminals, you can only plug them into the Coupler after passing through the mounting Plate.
It is cheaper to prepare an extra Coupler and a terminal because the terminal removal is very expensive, and to cut it and make a new one when it fails.
In addition, when it crimps the terminal whether it is because Wiring is thin, it bends inevitably, because it does not light by the lack of insertion to Coupler, when it pushes with the toothpick etc., it enters to the depth, but because WaterproofSeal also comes with when the toothpick is pulled out, a little. The finish of Waterproof is doubtful.

However, I thought it would be quicker, cheaper and more reliable to cut the OEM wiring and connect it with the Hot-melt tube if the vehicle inspection would pass without fail.
In addition, it is rare for people to replace OEM LEDs with external LEDs…I realized that today after writing this…

However, when I go out to a distant place for touring, etc., if the blinker comes off, it takes unnecessary time and effort to recover, and although I can run with it off, I am glad that I replaced it because of the visibility and the plastic shaking.

Helpful?

After the Rear, the Front!

Excellent

Oct 22, 2021

I installed it on the Front following the Rear.
At a quick glance, it's hard to tell where the Blinker is attached, but when it's lit up, it has an outstanding presence!

Helpful?

You can make Blinker disappear!

Excellent

Oct 15, 2021

CRF250L I'm on a MD47.

With the change to EnduroTail, I also changed the Blinker!
I didn't want to give too much away about the Blinker, so I chose this Blinker.
It's so hard to tell exactly where it's attached.
But it's so bright!