MOTOSKILL
Crash bar CT125
SKUMTSKL_0062GLBLK
HONDA
- CT125 CT110 HUNTER CUB
We purchased this product, which has an overhang at the bottom, to protect the Engine in the event of a fall, and we were prepared to do additional work.
Before temporary assembly, the mounting holes of the Under Guard were 2mm gapped at the Rear when aligned at the Front, so we enlarged all four mounting holes of the Under Guard to allow for future removal.
The product itself was also open, and when the Front was fixed to the car body, it needed to be pushed in with a lot of force to fix it to the lower part of the Engine. When welding, it was as if a bent Pipe was just welded without using a jig. Once installed, the front end is never removed, so we used brute force to get it in place.
Even though they are the same Made in Thailand, they are considerably less accurate than H2C's products.
We purchased the product knowing all this and are openly satisfied with the appearance of the product after installation.
Some modification is required when installing on the vehicle.
Why is the hole with Under Cover so Gap?
