MOTOLED Edge Holder Kit

This one was not so aesy to install i had to modify it slightly there is no protection for water so you have to make one yourself. After a little modification i am satisfied and it looks awasome

[How is it used?
Forest Road - Mountain Play

Was the one you received as per Image?
It was basically as pictured, but when I picked up the actual item, it was more delicate than I thought it would be.

Was the installation difficult?
Structurally, it was simple, but there was only one diagram that wasn't very clear, so
I was troubled a little by the replacement of the Bracket which is positioning the Rear Fender.
Other than that, it's a mysterious structure with Washer between Frame and Kit and Bolt from top and bottom.
When assembling, the Washer between the two falls out and it is very difficult to work.
If you use high viscosity grease to hold the position, you can do it....

How was your experience with it?
It looks nicer and it's easier to change Tire with more Space.
However, this was not strong enough at all to use it in Off-road though I had imagined it somehow.
Even if you fall lightly and the Number gets stuck in the soil, the Plate will bend in the direction of the day after tomorrow.
It may be for weight reduction, but it's a structure that simply bends a not-so-thick board, so
It is easy to say that it is easy to bend back by hand, but it is likely to break while driving by the fatigue of genus Gold sooner or later.
I bought this product because there is no Fender Eliminator other than this product at present.
It seems better to think of it as a bridge until a product with a little more strength is released.

[Included Parts:were they on?
It was on without excess or deficiency.

[Was there anything that disappointed you?
It's not as strong as I thought it would be.