[Kit Contents] 1. LED customizing board sequential type assy For front and rear blinkers / 2-wire 120° Pin Type........ 4pcs 2.Tapping screw M3 x 30 4pcs 3. Plastic spacer 4pcs 4. Nylon Washer for Tapping 4pcs
*If the flashing cycle is not compatible with the LED blinker relay, it will not work properly.CF POSH blinker relays must be purchased separately and the blinker relays must be replaced. *There may be changes in product specifications due to the manufacturer's reasons.
■□■Regarding Sequential blinker specifications■□■
1. cycle 1sec-0.5sec (More than 60 times per minute and less than 120 times per minute / Product flashes 73-75 times per minute)
2. the following conditions must be met when flashing light sources are produced by chain lighting
(1) Each light source remains lit until the end of the ON cycle after it is turned on. (2) The lighting of the series of light sources occurs uniformly and progressively from the inner to the outer edge of the apparent surface. (3) No repetitive alternation in the vertical direction (e.g: A single continuous line (without waves). (4) The variation ends within 200ms after the start of the ON cycle.
For vehicles with a single front blinker bulb and a position lamp. LED sequential (chain) blinkers that can be integrated into the stock blinkers. A set of circuit boards without dedicated indicator relays for compatible vehicles that already have LED blinker lights.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Originally I used to use LED Blinker, but I wanted a Sequential type I did I was hesitant to install it because most of the external ones were completely replaceable It was POSH's looks NORMAL because it replaces the contents of the OEM, and when it lights up, it looks NORMAL I bought it because it's sequential It's very easy to work with; it takes some time to remove the Seat Cowl and replace the Relay, but it's not too hard to do But.. Replacing the Blinker takes less than 30 minutes because you just have to replace the contents
The lighting status is the same as NORMAL (Normally, the position is lit, but when you add a blinker, the position is turned off Blinker lights
Note that the Hazard in NORMAL mode is no longer available
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!