*It is not completely waterproof. *Please make sure that the engine and exhaust are sufficiently cooled down before covering them. *By protecting your vehicle from direct sunlight, wind, rain, sand and dust, the motorcycle cover will always change over time.The color may fade depending on the usage conditions. *When a top box is installed, the overall length of the box attachment bracket tends to increase by approx. 200mm. The models are the list of reference models considering the BOX.
* The image is only for reference. The image shown may differ from the actual product.
Highly durable and water resistant black cover. Black has meaning.
Newly developed special material fabric with high durability and water resistance to overcome rain, which was realized only with black fiber. Rainproof motorcycle cover made of fabric with a threatening water pressure of 20000mm. The original cutting pattern and seam treatment of the seams prevent water infiltration. *Water pressure resistance / 500mm for general umbrella.Typical rainwear is 10000mm.
■Air Ventilation Air vent mechanism for better ventilation. Discharges moisture from the left and right mirrors.
■Pre- and post-discrimination The front side lock hole slit is colored red and the rear side lock hole slit is colored yellow to distinguish front and rear.
■Resistant to heat Heat resistant inner lining is used at the exhaust contact point to prevent the cover from melting due to heat from the engine and exhaust.
■Strong against wind The one-touch belt at the bottom center of the vehicle and the lacing at the rear prevent the cover from flying away in the wind.The belt can be removed from either side.The drawstring can be fixed with hook and loop fastener.
■Resistant to rain Newly developed water-resistant fabric 10-20 times more resistant than ordinary motorcycle covers. In addition, the watertight treatment is applied from the back side of the sewing line where water can easily seep in, and water penetration is thoroughly prevented.
■Resistant to theft Chain holes at front and rear for large locks. Don't bother to flip the cover to lock the chain.
■Comes with a dedicated storage bag The bag is large enough to store the bike cover even if you fold it roughly. Mesh design for easy drainage even in wet covers.
Used on previous generations of Motorcycle (XL1200X, ZX-25R, Z900RS). I have used it for about 2 years and there are no tears or fraying. It is also highly water-resistant, and in the beginning there was almost no leakage (after 2 years, it starts to soak a little). I think this durability is very cost effective at this price.View Detail
It is quite itchy. Of the several features, my favorite is the color coding of the lockhole Slit to easily identify the front and back. Also, the wind protection. I deal with it by squeezing the Belt at the bottom of the vehicle and the String turned around the entire bottom. The Surface Fastener, which holds together the String that has become longer by pulling, is very useful. I have been using it for a year. No problems at all.View Detail
Used on GSX-R1000R 2022 I used to use the L Size on my GSX-R750 2011, but the rear tire was sticking out due to the lack of height in the back, so I had to go up one size.
In terms of size, as you can see in the picture, it can cover the rear wheels well. But overall, the front is a bit too much and the back is quite limited. It would be nice to have the Size of the recent Full Cowlfor Vehicle.
For the attached Heat Seat, I installed the Cover once, and checked where the Silencer would hit, and marked the four corners. I turned the cover over and pasted it using the marking position as a reference. I think the OEMSilencer on the R1000 is on the large side, but I was able to cover it well enough.
I replace the Motorcycle Cover every time I inspect my car. The color was faded but not damaged, so I don't think durability will be a problem.View Detail
Last time I bought one for my KTM DUKE200, I was convinced it was too good to be true.
https://imp.webike.net/article/513016/
I bought a new 250cc class motorcycle, so I had to buy a new Cover.
The KTM is 2029mm, 836mm wide, 1267mm tall, with a GIVI 48L top case... "Standard 3L." The Cover is a little short at the bottom but a little long at the front and back, so the Tire is good because it manages to hide more than half of the slack room!
The additional car is 2005mm, 785mm wide, 1030mm high, and has a great Windscreen instead of a small one, and it has a 48L Top case, so it doesn't need length, but it needs height, so I chose LL length rather than 3L to cover the Top case. here
Top case for Vehicle LL I will update the Foot feeling including the feeling of use later.View Detail
This is the third time I've bought one of these. This product is one of the best waterproof motorcycle covers on the market. I think it's pretty cosy overall. I'm happy with the Waterproof performance as you can tell from my third purchase. Durability is 2 years in my case with no problems at all, other than performance. Also, the color black is very good and it is not noticeable at all at night, so you can feel safe because of the security effect. The rear hem ties are one of the large points that I love about this Motorcycle Cover. I don't feel the need to fix it with the BuckleBand in Center unless it's a strong wind because I can easily hem it and fix the excess cord with Magic tape. The holes for the Tire Lock are also a different color to make it easy to identify the front and rear of the Cover, and the holes are not bracketed, which is a common problem with cheap products, so you don't have to worry about damaging your motorcycle. There is a ventilation system on both sides of the mirror. The sticking Seat for Exhaust System heatproof is attached, but... In the first place, I don't do the cover until it cools down because I don't want moisture to accumulate in the cover by heat while the engine and exhaust system are hot. So I guess it's unnecessary. I'd be more than happy to lower the price for it. (Lol) 。 I think that it is a good Cover that goes satisfactory in function, durability, ease of use, price, and the total while there are various Cover that are expensive even if there is an effect from a cheap thing that goes bad immediately. Recommendation.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!