Plarepair Sheet

I used it where Cowl is cracked.
Cracks that are just straight up and down, or where the Cowl is completely cracked to the three-dimensional part that holds it in place.

Since I used it for the first time, I used a large amount of liquid to repair the area around the bolt hole, which I applied first, because I wet the area with the liquid all around as explained, and I stained it, but after curing, I can see the feeling that it is firmly attached, so it seems to have more effect than I wanted.
Because I reflected on the failure, and the part of the second small crack dripped and used only a necessary part, I was able to install it beautifully without Cowl becoming dirty.

I was wondering if I should use Seat for the part that is another three-dimensional, but I don't know if I should try it once, so I tried it and there is no problem with this part.
If you just stick it here, it will be stretched and floating.
1 Cut into the required size
2Only the protective Seat is peeled off, and the cut is put in the place where it becomes taut according to the adhesive part, and it eliminates it.
3 Cut the Repair seat according to the cutout of the protection Seat
4Prepare a thin object so that you can attach it firmly to the back where your fingers cannot reach.

If you do this, you can do Image pasting with protective Seat, so you don't have to fail than doing without thinking.
Just be careful that you don't make cuts for these parts of the Poly Seat as well, or it will look messy.

As for the curing time, I worked in a place where the temperature was 20 degrees Celsius and the sun didn't shine, and even I, a clumsy person, was in time to put it to the desired place.



If there is a complaint, it is that there is no Black in color.

It is used for repairing the cracks of the bracket attachment part and the side cover of Cowl.
Especially Cowl was cracked again in a few weeks after Repair by only Plastic repair or the influence of vibration, but it seems to be no problem after reinforcing by Plari Seat.

If you want to make it along a large step, you need to hold it until it hardens to some extent, otherwise Seat will float.

I used it to glue & reinforce a broken Cowl.
As for the adhesion of the broken Cowl itself, I applied the Soldering iron to the Reverse side and attached it, but I thought about the strength and used this.
It seems to have been used and reinforced quite well.

If I were to raise a drawback, it would be that the solvent smells (well, it can't be helped), so ventilation is necessary.
Does that mean there is only one Seat?

A few more Seats would be nice to have to say.

I used it to repair the damage caused by Cowl's ageing.
I have repaired it by Plastic Repair before, but I don't know if it is because of the vibration.
The Repair part cracked after a few months, but the Prari Seat is quite strong and can be used as a
It is safe to use
The color of the seat is white, but if there is a black variation of the color, the range of use seems to expand.

Not only Motorcycle, but also Material:It is convenient to use for Repair of plastic products.

There are plastic repair products that use powder and liquid repair, but if you use this product on moving parts or places where there is constant vibration, it will break again. It can be used on a variety of plastic parts other than motorcycles.