Take note: In my images, handlebar appearance will seem dull as i have spray painted over it to hide scratches i made when installing it. Original apperance is very glossy.About quality:No issues with the quality, however would have preferred a powdercoat finish to the acrylic coating.About design:Handlebar curves up first before sweeping down so you get the angled cafe racer handlebar look without sacrificing comfort and having to bend low.About fitment:Compatible with my bike's stock handlebar clamp, as the design is similar to the stock handlebar where the diameter is 22mm but thicker in the middle section at roughly 28mm. The handlebar turning radius is slightly affected whereby "full-lock" is at 95% now but it doesnt give me any problems whatsoever. Its only just touching but not scratching/slamming into the tank coverset, when pushed all the way to one side when parking. All switches housing unaffected, no need for rewiring/changing throttle cable length etc, but you do need to slightly adjust the tension in the throttle cable from the locknut thing.Difficulty of installation:Easy, did my first ever handlebar swap with this.
View Detail- Sale
- Instock
82.2 USD (12,476 JPY) 88.95 USD Save 8%
Delivery Information
-
Please select product form first.
FITMENT
-
XSR900
16-17 RN46J (30mm down 5mm forward)
-
MT-09
17-21 RN52J (30mm down 5mm forward(*1))
-
XSR700
17-21 RM22J (20mm down 50mm forward)
-
MT-09
14-16 RN34J (30mm down 5mm forward(*2))
Product detail
Material: Steel
Size: Width 680mm / Height 90mm
End Inner Diameter: 18mm
Clamp O.D.: Φ28.6
Grip section: Outer diameterΦ22.2mm / inner diameter Φ18mm
*
*MT-09 requires a separate meter movement bracket (HM3568)
*Made with switch holes.Structural changes are necessary to narrow the width.
*The position ratio is the same for both XSR900 and MT-09.
Side cap for handle inner diameter Φ18mm is separately required.
*Images may contain other colorings and types..
.
Narrow width and large squeezing angle position is set up with the condor handle shape that matches the pipe diameter to each part
●Position 30mm down from stock, 5mm forward
●The handlebar width is 85mm narrower and the squeezing angle is +17 degrees
●Steel, switch holes pre-machined, bolt-on
●The center side is equipped with a machined chrome plated cap
●The cables and hoses can be left as stock
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
New Motorcycle Rider
your bike looks sexy
18 days ago
Marshall
@New Motorcycle Rider Thank you very much, you too
14 days ago