*Do not dry rub as it is easily damaged. *If it gets dirty, wash it with a soft, scratch-resistant cloth and neutral detergent in a large amount of water. *Do not use organic solvents such as gasoline or thinner, or cleaners containing compounds. *To ensure safety, use strong double-sided tape to fix it and then use tapping screws to fix it firmly to the body cowl. *When using the tapping screws, it is necessary to process the preparation hole.
Prevents coldness around the knees and makes you more comfortable! Sporty aero form side visor left and right set.Impact-resistant acrylic (2mm thickness) is used.It reduces the wind hitting your feet when running and reduces the cold and fatigue.Use the included super strong double-sided tape (already installed on the side visor) and small tapping screws to install.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
It was fall when I first bought it. I didn't want to be cold due to the wind on my knees, so I bought it and wore it
After doing a thorough pre-treatment of degreasing etc Peel off the peeling paper and come forward while positioning "Ku Once the position is fixed, use a separately prepared moving tape to fix the corners of the "2" shape If you peel the release paper forward one at a time, it will stick nicely It depends on the temperature, but it was a little cold when I installed it, and the shape of the tape was a little different from the outside After the installation, I used the Heat gun to suppress the inside of the same Visor I was able to secure it firmly in place by making sure that I had an adhesive surface to which it would be fixed with tape
By the way, the screw of the prevention of falling off is attached, but I didn't want to process the body and visor Fixed as unused It's been over a year since I installed it and it's attached securely with only the included tape
The fit is pretty good, the wind on my knees is lessened, and it makes winter driving a lot easier If it's raining after Small, the area that gets wet while driving is reduced It's also my personal opinion that, on a windy day, I'm not sure if I'm going to be able to run on a bridge or a bank The bike may be a little flaccid, but as long as you are aware of how well it fits with the bike, it won't be too much I have never felt fear We have a lot of work to doView Detail
I installed it in PCX 2016. Summer was good but I headed for the winter season and my feet are a bit cold so I found this item when I checked the countermeasure Easy to impress (Impressions) I will write 1. First of all, Quantity : Pair (for Left and Right) I also looked at the side OEM I want to see Exactly fit without any gaps.
2. Installation was unexpectedly easy, but the bottom treatment wiped the surface gently with a mild detergent and dried before installing
3. Protecting the surface Although it was stripping off and peeling off Seal, you need to be careful not to scratch it when peeling it off
4. I peeled a little strong Seal of adhesive and pushed it little by little to paste it on the examination, but I carefully stretched it so as not to be Gap
5. After installing One Side, it will float unless you hold it down enough - - - It is warning because it floats considerably I pressed it firmly from top to bottom several times.
6. After finishing installing Both Sides, I checked the float by the final check and pull a little to see if it could peel off
Although installing a little care is necessary, it was able to install safely.
Although it is imp of running, it is impression of running lightly in the neighborhood, but although the hem of Pants was swinging with the wind until now it seems that there is a considerable fitting effect.
Since I am not running at high speed yet, there is no impression on that point, but I think whether it can be expected if it is this minute
This time it was written for Screw stopper for safety, but this time it was installation with adhesive tape, but if there is something to be off, I think whether you have to consider Screw stopping. View Detail
There was a PCX in First Model Type until now I finally installed it because it was not in the Second Type Model
Fit feeling is preeminent and it will not last until Limit Is it a good sea plum to say
Just as Double-sided Tape hits the part of the solid surface of Curve It can be added immediately Tapping screw is included but I did not install it The Instruction Manual is also attached, and the installation method is also written
The wind at your feet will also weaken, and flow into the snake at the time of rain will also Prevent. It seems to be active in winterView Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!
?
