When it comes to removing rust from a gasoline tank, the effectiveness and finish of the process differs greatly depending on whether thorough arrangements were made or not.
High-performance rust removal chemicals remove rust from steel plates.
Here's a great example of how effective it is! Let's try "Gasoline Tank Rust Removal".
Change the "dilution rate" depending on how severe the rust is.
The practice tank was badly rusted this time, to be honest. However, I was lucky that the inside wasn't getting nasty from the altered gasoline. This time I started removing the rust with 10x dilution.
The undiluted chemical solution was put into the kettle at a dilution ratio of 10:1 to the tank volume, and the kettle was boiled. Pour in the hot water and pour it in until it is full to the brim. Eventually the water should be lukewarm, around 60 degrees, which is enough.
Install a rubber plug on the fuel cock fitting, close the tank cap and shake the tank body to remove the rust. Let's turn the process fluid around. If there's an air chamber inside the tank, it's impossible to get rid of the rust there. Turn the tank around once every half day to check how the rust is coming off.
This is gross! Blanket all over!
Even if you start working with lukewarm 60-degree tailoring, you'll still be able to roll it up in a circle with a blanket you no longer need (this time If you work indoors, you can maintain a warm treatment liquid even after a day and night. If you pay attention to the temperature of the treatment solution, the rust removal activity is extremely high!
POINT:
Point 1. Use the rust removal chemical after removing the gas stains.
Point 2. Dilute it with lukewarm water to judge the degree of rust.
Point 3. Wrap the blanket around with a full mouthful of water. It is a shortcut to success to keep it warm!
In our Motomechanic Editor's Garage, we remove three or four rust from the gas tank a year. Practice. The most important part of such a process is before using high performance chemicals. In other words, the process of removing the "dirt" caused by the rotten gasoline. If the tar and varnish have been removed, then the rust has already been successfully removed at this stage is convinced.
Rust remover chemicals only demonstrate high performance in removing rust, but for oil stains, they Our editorial team's impression is that it is not strong enough. The gasoline tank changes, and depending on the rust and dirtiness of the tank, different working methods and steps are required. In some cases, a stage can give better results. For example, large containers, specifically those called "vessels" used for kneading cement and mortar and gasoline that has been cleaned of dirt by pouring a chemical solution into a small bathtub, or "hot tub" that is no longer needed. You could submerge the tank completely and then use a throw-in heater to heat the chemical solution further, but this In our experience, this "submersion method" has given the most favorable results.
However, this method can be said to have been successful if the rusting condition of the installed tank matched the working method. , I guess that's it. In any case, by using the ideas and enjoying "tinkering with bikes" in a variety of ways, we can better It's something that gets results.
High-performance chemical ideal for tank rust removal
Hanasaka G Tank Cleaner" by Ei Giken, a one-component, environmentally friendly neutral product. We are a pioneer in high-performance chemicals, and we are still the number one supplier to many repeat customers.
This is another highly popular Daytona "gasoline tank rust remover". It used to be sold in large bottles for commercial use, but now it's covered in 1-liter bottles.
