KEIHIN 32.Adjust Screw (Repair Part)
I am using a chemical oil in FCR28
Because the original Adjust Screw has been broken
The original quality is very good....
 | ||
| |
KEIHIN 54.O-ring (Repair Part)
I used it for Carburetor overhaul of KawasakiZXR250.About 1/3 the price of Kawasaki OEMParts.This part is for FCR Carburetor Body, but it can be installed on Kawasaki OEM KEIHINCVK30.There are also ma...
KEIHIN 22.Rip Seal (Repair Part)
MaintenanceCycle is important for FCR Carburetor Body unlike Normal cab.This Rip seal and Rubber parts such as Plunger (Diaphragm) of acceleration pump are regular replacement parts.As you know, the T...
KEIHIN 85/66. O-ring (Repair Parts)
KEIHINCVKcarburetor is used not only in Kawasaki but also in many other models at that time. I have been looking for the parts catalog of other companies. This time, I found the suitable O-ring from R...
KEIHIN Slow Jet
I bought this because I was doing an Overhaul on my Carburetor and the Slow Jet was changing shape. This time I bought the same number as OEM, and although I did not feel any change by the exchange, I...
KEIHIN 34.P/S O-ring (Repair Part)
This is the O-ring that is attached to the Pilot screw, which is the smallest O-ring used in the Carburetor.This is a part that should always be replaced during regular maintenance, but there are a fe...
KEIHIN 37.Valve Seat O-ring (Repair Part)
This is the O-ring that is installed on the outer circumference of the valve seat. If the O-ring is worn out, it will cause unstable oil level and overflow, so it should be replaced at the time of reg...
KEIHIN 82.U-ring (Repair Part)
Each Body of FCR Carburetor Body is connected to each other. "Air ventPipe. This is the URing ofUnlike the Fuel Pipe which was sealed with O-ring. URing. Note that it is sealed inIf you don't read the...
KEIHIN 45. Float Chamber O-ring (Repair Parts)
This is the Gasket of the Float chamber.In the case of FCR Carburetor Bodycarburetor, all four float chambers are connected by rubber hose, so it is very difficult to remove one float chamber for main...
 | ||
| |
KEIHIN 74.Funnel (Repair Part)
Since we installed the Catch tank behind the carburetor, in the Standard Funnel, the handling of Blowby hose seems to be in tight contact with Funnel so we purchased Short funnel and exchanged it.
KEIHIN 74.Funnel (Repair Part)
LongFunnel 70mm to Z400FX will be hurt because the clearance with Frame is too narrow.I bought this show and Funnel 45 mm daringly, but the price is high ... (You can buy Aluminum Funnel smile)Because...
?
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING