- Fits:
- HONDA Monkey 125 18-
It arrived today in the morning, no problem to check the product, I temporarily matched it to the Fender and it fits perfectly, it looks like an OEM Product, it is thick and solidly made, it is a down...Read More - Fits:
- YAMAHA BOLT 14-16
I installed it on my 2021MODEL. It is cheaply made, but I feel no problem to integrate it with Fender.We have not used it in the rain yet, but we expect it to reduce mud splashing.Read More - Fits:
- HONDA NC750X 21-
The NC750X's Front Fender is short and often gets dirt up to the Radiator when driving over puddles.To mitigate the damage as much as possible, we installed this product.We did not use the supplied do...Read More - Fits:
- HONDA GROM 21-
I think it is effective Large for those who ride to work etc..on rainy days like Title.I never ran in the rain. (Impact of increased telecommuting) It will be a decision of about 5? on the way back.I ...Read More - Fits:
- HONDA NC700S 12-
- HONDA NC700X 12-
- HONDA NC750S 12-
- HONDA NC750X 12-20
[How is it used? Extension for short FFender.Was the one you received as per Image? usuallyHow was your experience with it? usually[Points to note] The Pin of the resin is poor.How did it compare to o...Read More - Fits:
- YAMAHA MT-07 14-17
I'm sure it will look bad, but it is practical. I don't have a photo of it as I don't have a vehicle at hand, but it has reduced the amount of mud splashing from stepping stones. I asked a motorcycle ...Read More - Fits:
- HONDA GROM 21-
I was concerned about the double-sided tape that came with the product, so I used the Scotch vehicle tape I had on hand and installed it on the FFender.Even if you don't use the supplied Anchor Pin, t...Read More - Fits:
- HONDA GROM 21-
The double-sided tape that comes with the product has a little bit of anxiety about the adhesiveness, so I used 3M's Double-sided Tape for Cars as the main adhesive.Then, even if you don't put the att...Read More - Fits:
- HONDA X-ADV 17-
There was a lot of bouncing off the front wheels when it was raining or there was water on the road, but after installing the Extender Fender I was pleased with the effect. It is best to remove the OE...Read More - Fits:
- HONDA NC700S 12-
- HONDA NC700X 12-
- HONDA NC750S 12-
- HONDA NC750X 12-20
I installed this on my NC750X 2021.I installed it because the Fender is too short for OEM and it makes the car body dirty.It is recommended to fix it with Double-sided Tape and Pin, but since the qual...Read More - Fits:
- KAWASAKI Ninja1000SX 20-
[How is it used?Immediately after completion of installation, before use.Was the one you received as per Image?As per Image. There are no flaws or distortions to worry about, and the appearance qualit...Read More - Fits:
- HONDA 400X 13-18
- HONDA CB400F 13-18
- HONDA CB500F 13-21
- HONDA CB500X 13-18
- HONDA CBR400R 13-21
- ...and more.
Cannot be installed as it hits the tireBecause it's a 20 year MODEL?Read More - Fits:
- HONDA NC700S 12-
- HONDA NC700X 12-
- HONDA NC750S 12-
- HONDA NC750X 12-20
我的车是厂牌是本田,车型是NC750X,年份是2020年10月。我在webike上购买了P&A的前挡泥板商品,它的材质是塑料;不知道为何原车的前挡泥板这么短?安装这个延长板的时候要把原车的前挡泥板拆了,用3M胶固定,最好用3个或者4个铆钉固定好,还是不能骑太快,否则还是会甩的水箱散热板上。
----------------------------------------------
M...Read More - Fits:
- HONDA GROM 13-15
I installed it on the Grom.The Size of the extension is also just about right, which is nice.The reason I wanted to install this is that the NORMAL Fender is shortEven the top side of the cylinder hea...Read More - Fits:
- SUZUKI SV650 16-
The design and quality of this product is perfect. The front fender is too short to begin with.Read More - Fits:
- TRIUMPH Speed Triple 1050RS 19-20
- TRIUMPH Speed Triple 1050S 19-20
- TRIUMPH Street Triple 765 17-
- TRIUMPH Street Triple 765R 17-
- TRIUMPH Street Triple 765RS 17-
- ...and more.
After purchasing the Rear Extend Fender for the dirt around the R suspension, the Front was purchased because....3mm (I think it was 4mm?) The structure which makes a hole with the Drill of the "Mere ...Read More - Fits:
- YAMAHA FJR1300A 06-
- YAMAHA FJR1300AE
Front fenders tend to be shorter these days, and although parenthesis is good, there are more water splashes and small stone ricochets, and more scratches and dirt on the engine, exhaust pipe, and rad...Read More - Fits:
- HONDA CB1000R 18-
Radiator guard is less and more expensive, so I chose it insteadNo Gap or blur when glued together with just 3M SealHowever, it is preferable to have an environment where drilling is possible because ...Read More - Fits:
- BMW F900R 20-
- BMW S1000R 14-20
- BMW S1000RR 10-18
- BMW S1000XR 15-19
I cut it about 15mm because it makes contact with the TireStill, Clearance is no more than 5 millimetersI think it's a Universal Product, not 900RSpecRead More - Fits:
- KAWASAKI Z900RS 17-
- KAWASAKI Z900RS Cafe 18-19
- KAWASAKI Z900RS SE 22-
The product looks cheaper than the price lolBut it's Mudguard, so if it works, it's goodIn the instructions, you are advised to use PlasticRivetI had some resistance to make a hole in it, so I used on...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING