KAWASAKI Ninja ZX-14R (ZZR1400) Custom Parts and Customer Reviews

TANAX Cowling Mirror 6

Bought the TANAX Cowling Mirror 6 to replace my oem side mirrors. Easy to install instructions, very versatile in every angle unlike the oem mirrors.
However I replaced the original screws supplied with stainless steel screws to prolong the life of the screws and to prevent rusting of the origin...

Products Details

GIVI Easy Lock BF04

Without this Easy Lock TanClock can not be installed so it is only a part to buy.Part of Main was warped rather than flat, so I thought of turning in a moment.Ninja 1000 '15 MODEL, opening and closing of filler opening was OK without installation problem. A friend of the current Z1000 seems that...

Products Details

BABYFACE Frame Slider

I used OverRACING, but because it is hard to remove the SIDE fin, I replaced it with this product. Easy to remove as it leaves the center of the fin. Since the product of Over gets out from under one, it scratches and struggled to remove the fin. However, because it is above the product of Over, whe...

Products Details

TANAX Cowling Mirror 6

OEMMirror's visibility was bad so I exchanged it.After exchanging, I ran several times and adjusted, but it will be difficult to see blurred Mirror from about 80 km / h. Especially Right Side becomes hard to see. Stopping the Mirror If you tighten the Screw tightly by diverting the OEM, the shak...

Products Details

DAYTONA Special Air Breeder

The shape of the tip is slightly different from OEM. I feel a sense of incompatibility when I put on Rubber cap.Seal tape winds in the reverse direction, not in the tightening direction.Noticing that Brake fluid seeped out of Caliper's Air breederRust was amazing as I removed it. Indeed when I t...

Products Details

NGK Iridium Plug CR9EIA-9 6289

Purchased because use of Iridium plugs was specified as Manufacturer.It is stable quality.However, saving a little if it is cheaper.6 thousand yen in 4 pcs...

Products Details

OVER RACING Racing Slider

Compared to other Manufacturer's Slider, it is not attached to direct, so it seems to escape shocks well!Also, in the case of 14r, the Slider of Over comes to a lower position than other Manufacturer, so even if you defeat it by eggs etc., Cowletc. It is likely that scratches will be less.Gold a...

Products Details

DAYTONA Special Air Breeder

Noticing that Brake fluid seeped out of Caliper's Air breederRust was amazing as I removed it. Indeed when I thought this was dangerous, I found this productReplaced. As I wrote that the installation was to tighten Seal tape one half turn and tightenI rolled Emon's Seal tape. It looks more m...

Products Details

DAYTONA Aluminum Cut-out Adjust Brake Lever

In the past I was using a certain U ~ Lever, but Brake's effective Timing is different, I'm worried with the corner of LeverWas itMr. DAYTONA likes it because it works with Timing which is almost the same as OEM, and I feel like I did not care about it, so I like it

Products Details

ALBA G GRIP Slip-resistance Seat Replacement Servi...

Seat which was completed was sent back, and when opening it, I first cared about Wrinkle. OEMSeat is not possible Wrinkle. I used it several times, but Wrinkle will not go away. I do not think that we are pulling out hands, but would not it be better to make the final check after work a bit more str...

KAWASAKI Ninja ZX-14R (ZZR1400)

Recently viewed products